Thursday, September 24, 2009
Classes Postponed
Wednesday, September 9, 2009
October class
Wednesday, August 19, 2009
September Project
1 yard of washable material. I love duck cloth or a poly cotton blend. These are thick and wash great!! I usually get it at walmart for $1.50 a yard. Also a note. 1 yard will make 1 adult size apron. 1 yard at 60" wide will make 4 child size aprons. you should be able to make between 2-4 child sized aprons out of 1 yard. It will just depend on your width.
2.Cut out 1 piece of ribbon 25" long (neck piece) Cut 2 pieces of ribbon at 22" long(ties)
Child apron(not pictured) cut 2 pieces of ribbon at 8" long (neck pieces) cut 2 pieces of ribbon at 12" long (ties)
3.In curved sides of apron press under 1/4" with your iron. This will help to keep material from fraying in wash.
Repeat steps 3 and 4 on bottom of apron.
5.Now we are attaching the neck strap. With the right side of your apron facing you place the edges of your ribbon in the corners securing them with small pieces of heat-n-bond. It should look like this. It is important that you let the heat-n-bond cool before trying to pick the ties up. If you don't they will not adhere properly and you will have slipping ties!
6. follow steps 3 and 4 again for seam. Remember to allow time to cool before picking up.
7. Now we will add the side ties. You will follow the same steps as you did for the neck strap. Put your apron right side facing you. (As shown in the picture below) Put ribbon in the corners securing with small pieces of heat-n-bond. Hem as before following steps 3 & 4 (and yes that is my foot in the picture. I just didn't notice it until I was writing the sentence just before this one!)
Finish up by adding buttons at the neck. If you are doing the child size add your snaps to each end of your neck ties.
All right you are all done! See I told you these would be simple. Of course this is a very basic pattern you could add pockets and all sort of cute things on these to personalize them! Have fun making tons of these. I'm warning you they are addicting!
Sunday, August 16, 2009
Reciepe Card holder
1 Wooden frame. 5x7 for recipe card size. (I purchased mine from the dollar store)
piece of chicken wire to fit opening. (Lowes 10'x 24" was $3-4 you can purchase some from me for 1penny an inch)
Staple gun
hammer
decorative paper, wrapping paper, wall paper . . . I think that you get the idea. Cut to fit in your frame
buttons or other type of embellishments if wanted and glue to adhere them
mod-podge and paint brush
OK so lets get started.
1. So to start off you will want to remove the back and glass from your frame. You can throw the glass out but keep the backing you will need this later!
2. Cut a piece of chicken wire to fit the inside of your frame. Staple and hammer into place one side at a time pulling tight and shaping the wire as you go. Make sure that you staple all "loose ends" you don't want your wire to unravel when you trim it. Use your wire cutters to curl in your ends so that you have no sharp edges. The back of your frame should look something like this at this point. (Just a note -make sure that your chicken wire is going in the same direction pictured. If not your reciepe card may not fit.)


